Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Thank you. Looking it up right now...LibreCAD
The below is all I want: Just a dimensioned drawing of a simple tapered cylinder. I want to change the shoulder angle to twenty-four degrees. Click on the image to make it full-size...
View attachment 6650
Flat would be OK, but if you could crank-out a 3D model, that would be super-peachy.You want a flat drawing or a 3d model?
I'm pleased as punch you took the time to draw it. It looks fabulous. The only measurement that will decrease is the 1.7121" because the slope of the shoulder will decrease. Please keep the 0.450" at the lowered shoulder. Let me know what kind of adult beverage you drink, and I'll send you a money order to go buy a six-pack...You need to specify your dimensions. You just said a change in shoulder angle, you didn't say what dimensions you wanted to keep.
I remember from when I did my first mildcat round between July 2008 to its first firing in July 2012 that it's not possible to dimension the radius at the neck because there is no distinct point there. The member of the bulletin board of which I was also a member at the time said such a measurement makes the drawing "constrained" or "overly-constrained." I drew things for years and years on vellum with triangles and a T-square. I never knew much about constraints.. . . otherwise the sketch is over-defined.
Ditto on these, I use both and they are very good!LibreCAD. If you want something more, I would look at FreeCAD, between the two LibreCAD is the easier to use, FreeCAD is the more versatile.
Can a brain-damaged trucker learn to use LibreCAD in less than a year?I use both and they are very good!